Specifications

ooppeerraattiioonn
6 - Gemini Classic | Operation
RReeaaddyy IInnddiiccaattiioonnss..
Test Button.
The illuminated open-flash test button on the side of the unit
shows the charge state as follows;
LED off - No power
LED flashes quickly - Charging.
LED lit continuously - Ready.
LED flashes slowly - Dumping.
Ready Beep.
The Gemini Classic also features a built-in audible ready
‘beep’ indication where the unit will emit a short beep to
confirm that the unit has 100% charged and is ready to fire.
The 2-position beep mode control switch on the rear controls
the following functions;
Upper - (Off) No audible signal.
Lower - (On) Beep will sound at 100%.
CChhaannggiinngg tthhee MMooddeelllliinngg LLaammpp..
Switch off the Gemini and disconnect from the power supply.
Allow the lamp to cool before removing.
Unscrew the modelling lamp from the lampholder in the
centre of the reflector and replace with a new lamp.
Note: It is recommended that a Halostar bulb with a maximum
wattage of 275W is used. The manufacturer will not accept
liability for the use of any lamp greater than 275W.
BW1024 - 250W Halostar modelling lamp.
CChhaannggiinngg tthhee FFuussee..
The modelling and flash circuitry is protected by a single 5A
fuse mounted on the rear control panel.
Never replace the fuse with one of a different rating.
As the fuse may blow when the modelling lamp fails, always
check the fuse when replacing the bulb.
A spare fuse is supplied in the fuse holder.
Always switch the unit off and disconnect the Gemini unit
from the power supply before changing the fuse.
CChhaannggiinngg tthhee FFllaasshh TTuubbee..
Ensure that the unit is switched off and disconnected from the
AC supply and then wait thirty minutes before touching or
removing the flash tube.
Remove the protective cap and unwind the twisted trigger
wire from the flash tube support.
Gently pull the flash tube assembly out of the unit.
To replace the assembly, hold the flash tube as shown and
taking care to support both legs of the tube, gently but firmly,
push the flash tube into position, and wind the trigger wire
around the flash tube support.
Always replace with the correct flash tube assembly:
BW2032 - UV Coated. BW2030 - Clear.