Specifications

4 - Gemini Classic | Controls
ggeemmiinnii ccllaassssiicc ccoonnttrroollss
 Slave Cell On/Off.
 Ready Beep On/Off.
 Modelling Lamp Mode.
 Carry Handle.
 AC/DC Power Switch.
 AC Power Input.
 Spare Fuse Holder.
 DC Power Input.
 Modelling Lamp Level.
 Sync. Socket.
 Photo Slave Cell.
 Flash Test Button.
 Modelling Lamp.
 Flash Tube.  Power Controls.
 Reflector Release.
 Radio Trigger Card Slot.
OOppeerraattiinngg yyoouurr GGeemmiinnii CCllaassssiicc..
The Bowens Gemini Classic can be operated from either an AC (mains) supply or from a
Bowens Travelpak battery.
For AC operation, the AC switch (page 4) should be in the upper position.
For battery operation, the switch should be in the lower position.
The centre position is OFF.
NOTE: When operated from a Travelpak battery, the modelling functions are not available,
this is to preserve battery life.
• Ensure the power source is off.
• Connect the unit using the appropriate cable.
• If using the Travelpak, ensure the connector locks are fully tightened.
• Switch the power source on, then switch on the Gemini Classic.
• The unit will charge & indicate it is ready for use by lighting the green flash-ready LED.
• Press the test button to check the unit fires.
WARNING HIGH VOLTAGE!
Never connect the Gemini Classic monolight to a Travelpak
battery and AC (Mains) supply at the same time.
This appliance must be grounded when used with AC.
Disconnect the AC plug when changing modelling lamps and
flash tubes.