Specifications

11 - Gemini Classic | Specifications
ggeemmiinnii ccllaassssiicc ssppeecciiffiiccaattiioonnss
GGMM550000CC
500Ws
5 Stops
Rotary Dial
Rotary Dial / Proportional
No
Yes
No
Yes
No
BW2030 (Clear). BW2032 (UV)
No
250W Halostar (BW1024)
80
1.5 Secs
1/900
5600K ±300K
Yes
5V DC
190-250V AC 50Hz
Yes
±1%
Yes
Yes
145mm
370mm
130mm
3.0kg
BW3911
GGMM225500CC
250Ws
5 Stops
Rotary Dial
Rotary Dial / Proportional
No
Yes
No
Yes
No
BW2030 (Clear). BW2032 (UV)
No
250W Halostar (BW1024)
60
1.0 Sec
1/1100
5600K ±300K
Yes
5V DC
190-250V AC 50Hz
Yes
±1%
Yes
Yes
145mm
370mm
130mm
2.8kg
BW3901
MMooddeell::
Max Power:
Power Range:
Power Control:
Modelling Control:
Digital Display:
Plug-in Radio Trigger Option:
Multi-voltage:
Auto Dump:
IR Remote Control:
Flash Tube
Fan Cooled:
Modelling Lamp:
Guide No. (m/100 ISO)
Recycle to full Power:
Flash Duration:
Colour Temperature:
Flash Inhibit:
Sync Voltage:
Operating Voltage:
Travelpak compatible:
Voltage Stabilisation:
Ready Light Indication:
Audible Ready Sound
Width:
Length:
Height:
Weight:
Part No.:
MMoouunnttiinngg aanndd rreemmoovviinngg rreefflleeccttoorrss..
A range of reflectors is available for the Gemini range of
monolights. To mount, slide the neck of the reflector over the
front of the unit. Align the three pegs on the reflector with the
three slots in the retaining ring. Press down and turn
clockwise to lock.
To remove the reflector, pull back the reflector release (page
4), turn the reflector fully anti-clockwise and withdraw.
If an umbrella is to be used, a 120º Wide-Angle Reflector
(page 9) should be mounted and the umbrella fitted through
the hole in the mounting bracket on the reflector and locked
into position with the locking screw.
NOTE: Take care when mounting and removing reflectors not
to damage the flash tube assembly. The flash tube is very
delicate, avoid unnecessary handling of the glass tube.
Always switch the unit off and disconnect from the power
supply before fitting and changing reflectors.
WARNING HIGH VOLTAGE! DO NOT TOUCH THE FLASH
TUBE ASSEMBLY FOR AT LEAST 30 MINUTES AFTER
DISCONNECTING FROM THE POWER SUPPLY.
LLeeggaall NNoottiiccee..
Bowens® and ‘the power behind the picture’® are registered
trademarks of Bowens International Ltd. Due to our policy of continual
product improvement, Bowens International Ltd reserves the right to
change equipment specifications at any time and without notice. The
information contained in this user guide should not be relied on solely
before making a purchase, seek further information from your
photographic retailer. © 2010 Bowens International Ltd.