Specifications

modellinglampreplacement
Switch off and disconnect the unit from
power supply. If the unit has been in use,
allow a sufcient amount of time to cool
down before touching. Unscrew modelling
lamp from housing and replace with the
correct lamp type (see Fig 7.).
fusereplacement
The modelling and ash circuitry are
protected by a single 20mm fuse mounted
in the rear panel of the unit. A fuse may blow
when the modelling lamp fails; always check
the fuse when replacing a bulb. A spare fuse
is located in the draw underneath the mains
connection (see Fig 8.) at the rear of the
unit. The fuse draw contains two fuses, the
furthest fuse inside the draw is the live fuse
and the nearest one is a spare. Never replace
the fuse with one of a different rating. Always
switch off the unit and disconnect the power
supply before changing a fuse.
warning/errorconditions
There are four alarms / warnings on the
Gemini Rx to indicate possible function
issues. The alarms / warnings are shown via
the green ready LED; alarms / warnings may
also be accompanied by a beep (if switched
on).
1.) Charge Fail - Green ready LED will
continuously emit a brief ash and
intermittent beep.
2.) Overheat - Green ready LED will ash
once every 2.5 seconds.
3.) Misre - Green ready LED will ash
twice every 2.5 seconds along with a
beep.
4.) Glow On - GREEN ready LED ashes 3
times every 2.5 seconds accompanied
by a beep.
flashpowercontrol
The ash power is set using the single rotary
dial on the side of the unit. The ash power
output is variable over 5 stops, from full to
1⁄32. The max power output is dependant
upon the model (see specications) and
is denoted by the number 6 on the control
panel. The numeric divisions indicate one
full stop of ash power. Once the unit has
changed to the desired setting, the green
LED will illuminate indicating that the unit is
ready to re (may also be accompanied by a
beep if switched on).
NB. If the unit is subject to rapid operation
over extended periods, the unit may
automatically go into ‘overheat’. In this
condition, the ready LED will ash every 2.5
seconds while the charging and modelling
functions will be disabled to enable the unit
to cool. The unit will automatically resume
operation once cooled sufciently.
7 - Gemini Rx | Functions Overview
Fig 7. Fig 8.