Specifications

modellinglampcontrol
The modelling lamp on the GM200Rx and
the GM400Rx uses a phase control system
with a soft ‘on’ and ‘off’ to prolong the life
of the bulb. A ‘lamp saver’ function has
also been incorporated into both units that
will automatically turn on if no adjustments
are made or ashes red within 30 minutes.
When the ‘lamp saver’ mode turns on the
modelling lamp will ‘dim’ to min power.
The modelling lamp output is set using the
switches on the rear of the unit (see page 4).
The modelling output can be set to either
‘OFF’ (by setting the LAMP:MODE switch
set to upper position), ‘PROPORTIONAL’ to
the ash output (by setting the LAMP:LEVEL
switch set to lower position) or ‘FULL’ (by
setting the LAMP:LEVEL switch set to upper
position).
Note: When operating the Gemini from a
battery the modelling function is disabled to
preserve the power in the battery.
unitreadyindications
The modelling lamp can be used as an
indicator of when the unit is 100% charged
and ready to re.
The ‘LAMP:MODE’ switch on the rear of
the unit (see page 4) controls the modelling
ready indicator function. When the switch is
set in the ‘lower’ position the modelling lamp
ready indicator will be turned ‘on’, and will
extinguish the lamp when the unit is red and
will relight once the unit has fully recharged.
If the ‘LAMP:MODE’ switch is set to the
‘centre’ position the modelling ready function
will be turned ‘off’ and the modelling lamp
will remain ‘on’ continuously.
Both units also have a built-in audible ready
‘beep’ indication where the unit will emit a
short beep to conrm that the unit has 100%
charged and is ready to re. If the ‘BEEP’
switch on the rear panel of the unit (see page
4) is set in the ‘upper’ position the beep
indication will be turned ‘off’. If the ‘BEEP’
switch is set to the ‘lower’ position the ready
beep will be turned ‘on’.
flashtubereplacement
Ensure the unit is switched off and
disconnected from the power supply before
changing the ash tube. Wait for a sufcient
time until the ashtube has cooled down.
Once cooled, unwind the twisted trigger
wire from the ash tube support and gently
pull the ash tube out of the unit. To replace
the ash tube, hold as shown (Fig 6.) while
making sure to support both legs of the ash
tube, and gently push the ash tube into
position. Finally, wind the trigger wire around
the ash tube support. Always replace with
the correct ash tube assembly.
6 - Gemini Rx | Functions Overview
Fig 6.