Specifications

safetynotes-do
1.) Switch the power off and disconnect
from the power supply before changing the
modelling lamps or ash tube.
2.) Disconnect the power supply before
changing a fuse. Never replace the fuse
with one of a different rating. A spare fuse is
located in the fuse holder at the rear of the
unit.
3.) Exercise care when handling equipment
that has been in use. The reector and front
end of the unit can become very hot.
4.) Avoid placing cables where they can be
tripped over. Protect from heavy, sharp or hot
objects that may cause damage and replace
damaged cables immediately.
5.) Due to the high-voltage / high energy
used in the Gemini units, all servicing must
be carried out by a Bowens authorised
service and repair centre.
6.) Remove the power cord by gripping the
plug. Never pull the cord.
7.) Always remove the ash head covers
before using.
safetynotes-donot
1.) Use in an environment where moisture
of ammable liquid is likely to come into
contact with this product.
2.) Plug the Gemini into a mains supply and
a Travelpak battery at the same time.
3.) Restrict air vents while in use.
3.) Use a unit with damaged housing,
mouldings, ash tube or modelling lamp. If
the unit is dropped or damaged in anyway,
always have it checked before using.
5.) Operate the unit without a safe grounded
(earthed) supply.
connectingandusingagemini
Warning high voltage: never connect the
Gemini to both a mains supply and a
Travelpak battery at the same time. This
appliance must be earthed when used with
a mains supply. Disconnect the mains lead
when changing the modelling lamps and
ash tubes. The Gemini may be operated
on either a mains supply or with a Bowens
battery source, such as the Travelpak.
connectingandusingagemini
For mains operation, the ‘Mains / Battery’
power switch (see page 4) should be in the
upper position. For battery operation the
switch should be in the lower position. The
centre position is ‘off’.
power connecting instructions:
1.) Ensure the power source is switched
‘off’.
2.) Connect the unit to the power source
using the appropriate cabling.
3.) If using a battery, ensure the power lead
connectors are fully tightened.
4.) Switch the power source ‘on’, then turn
‘on’ the Gemini.
5.) The unit will charge and indicate it is
ready by illuminating the green LED
on the side of the unit (‘beep’ and ‘lamp’
ready functions are also available to
indicate when unit is 100% charged).
6.) Press the ‘Flash Test’ button on the side
of the unit to check unit res.
3 - Gemini Rx | Connecting and Using a Gemini