Owner`s manual

2. Press the DISC TARGET touch pad to “lock-in” the programming.
The blinking arrow under IRON/FOIL disappears and IR
appears in the TARGET readout (indicating that the detector
is set to accept all metals, including all levels of iron) as
shown in the following diagram.
▲ To select PRESET targets
The Time Ranger™ has three PRESET modes:
1. Perform the steps described in Turning the Detector ON section of
this manual.
2. Press the DISC TARGET touch pad.
A blinking arrow appears under IRON/FOIL in the Probable
Target ID fields, meaning the detector is ready for programming.
3. Press the PRESET touch pad once to select PRESET 1.
The blinking arrow under IRON/FOIL is replaced by an R.
4. Press the PRESET touch pad twice to select PRESET 2.
An R appears under PULL TAB in the Probable Target ID fields.
5. Press the PRESET touch pad three times to select PRESET 3.
An R appears under Z-1¢/S-CAP in the Probable Target ID fields.
PRESET 1
Rejects all levels of iron and aluminum foil.
PRESET 2
Rejects pull-tabs, iron and all objects rejected in PRESET 1 mode.
PRESET 3
Rejects zinc pennies, screw-caps, pull-tabs, aluminum, other similar
objects, and all objects rejected in PRESET 1 and PRESET 2
modes.
SNIFF
ALL METAL
SMART
TRAC
PRESET
DISC
TARGET
POWER
ON/OFF
BLANKER
15