Instruction manual

2-2 Desktop Features
Clock feature
You can enable the Clock feature without entering Set-Up by
pressing Caps Lock +Alt+F11 if you are not in an ASCII emulation
mode.
The current time is displayed in the status line if this feature is
enabled. The format is HH:MM, followed by AM or PM if the 12-
hour format is selected. Use the following keys within the clock
features:
Key Function
 or Tab
Go to next field.
 or Shift+Tab
Go to previous field.
 or  Move within a field.
Return or Enter
If desired, check the 24-hour
format box. For example, before
entering 13:00, enable 24-hour
format.
A or P
For 12-hour format, set the time
to morning by pressing A or P for
afternoon.
If the clock feature is enabled, then the alarm sounds for five
seconds or until a key is pressed. Each alarm message can be
up to 20 characters and will be displayed in the status line until
a key is pressed. If the hourly chime is enabled, then the
terminal will beep once every hour. In Set-Up, select the Save
settings menu item to save the time format. The clock feature is
disabled when the terminal is turned off.