User`s guide

STEP 8 – Emulation Setup Selection 21
STEP 8 – Emulation Setup Selection
This step requires setting a selection in the Setup menu to
configure the “Emulation” of the terminal. Determine which
emulation your applications run with.
Enter the Setup menu and set the “Emulation” parameter, in the
Quick (F1) menu, to match your requirements.
STEP 9 – Additional Setup Options
At this point, you should proceed to the Setup chapter and
continue to set up your own selections for any other parameters
such as those for the display, keyboard, function/edit keys, and
tabs.
STEP 10 – Save Parameters
Finally, remember to save your Setup parameters in permanent
memory, so that they can be recovered if the terminal is powered
down. When you exit the Setup menu, the prompt “Save all?
(Y/N)” flashes. To save parameters, press “Y”. Another way to
save parameters is to perform a “Save Terminal” operation, while
in the Exec (F13/Prnt Scrn) menu of Setup.
Remember to save your Setup settings after the entire
installation process.
STEP 11 – Establish Communications
Your installation is now complete. By pressing the Return or
Enter key, you should be able to communicate with the host
computer(s). The printer should respond to the local print
command, Shift-Ctrl-. (period on numeric keypad).
If for some reason, your installation was not successful, make
sure your physical connections are secure, that the
communications protocol settings match your devices, and that