JP06-106_201806 Magic Carpet Swing Assembly, Installation, Care, Maintenance, and Use Instructions USER’S MANUAL CAUTION This unit is designed to be used simultaneously by up to 2 children between the ages of 3 to 8. Maximum weight of each user is 100lbs(45kg), with combined weight not to exceed 200lbs(90 kg) WARNING Carefully read this entire instruction manual before you start to assemble or use this swing set. You must follow all safely instructions while using this equipment.
INTRODUCTION Dear Customer: Thank you for purchasing this product. We hope that you will enjoy it. It will take a little time to assemble it. Please take it as an exercise in assembling this product. It is not unusual for you to take more than an hour to assemble this product; so please be patient and enjoy this process with a friend. This play set is for residential use only. This play set is NOT intended for public or commercial use.
IMPORTANT INSTRUCTIONS AND WARNINGS WARNING READ ALL INSTRUCTIONS BEFORE ASSEMBLING OR USING THIS EQUIPMENT AGE LIMIT This product is designed to be used by up to two (2) children between the ages of 3 to 8. Maximum user weight is 100 pounds (45 kg) each with a combined maximum weight of 200 pounds (90kg). The play set is designed for children over three (3) years of age. Use by smaller children can result in entrapment. On-site adult supervision is required at all times for children of all ages.
Do not install your play set over hard surface, e.g. asphalt, concrete, packed earth, tile or brick floor. A fall onto a hard surface can result in serious injury or death to the user.
PLAY SUPERVISION DO NOT allow more than one child to play on the individual swing, trampoline or slide component at any one time. DO NOT allow children to stand on the slide, swing seats or glide ride. DO NOT allow children to walk too close to moving parts. ALWAYS keep a safe distance to avoid being struck by other children while playing on swings, slides, trampolines etc.
INSPECTION PRIOR TO EACH USE OR DAILY INSPECTION DO NOT use the equipment if any bolts or nuts are missing or loose. ALWAYS check to ensure the equipment and all parts are well secured and stable before each use. ALWAYS clear the play area of any rocks, sharp objects, or any materials that could be potentially hazardous to users.
ANCHORING (NOTE:ANCHORS ARE NOT INCLUDED-MUST BE PURCHASED SEPARATELY) There are different ways of anchoring the equipment, depending on the type of ground on which the equipment is to be installed. Make sure that all anchors are below ground level to prevent tripping. You should consult your local contractor to decide the most appropriate way to anchor the equipment in your location.
FRAME LEG 12-5/8” CONCRETE 5” 2” BRICK OR GRAVEL BED Note: The maximum fall height for this product is 6 feet. The minimum ground clearance between the bottom of the suspended plays and the playing or ground surface must be 8 inches. 8” You must maintain a minimum of 8 inches of ground clearance. WARNING Please properly anchor the swing set to minimize the risk of injury or death. If the swing set is used without proper anchoring, it may be dangerous and may tilt over.
CARE AND MAINTENANCE CHECKLIST AT THE BEGINNING OF EACH PLAY SEASON: Tighten all hardware. Lubricate all metallic moving parts per manufacturer’s instructions. Check all protective coverings on bolts, pipes, edges, and corners. Replace if they are loose, cracked, or missing. Check all moving parts including swing seats, ropes, cables and chains for wear, rust or other deterioration. Replace as needed. Check metal parts for rust.
TOOLS NEEDED Please prepare the following tools prior to assembling this equipment.
Part list Key Numbers Description Quantity A1 LEFT TOP BAR 1 A2 RIGHT TOP BAR 1 A3 UPPER SUPPORT LEG 4 A4 LOWER SUPPORT LEG 4 A5 CROSS BAR 2 B1 BOLT 5/16” x 2-5/8” (68MM) 4 B2 BOLT 5/16” x 2-1/2” (63MM) 6 B3 NYLON NUT 5 /16’’ 16 B4 PLASTIC CAP (WITH ARC WASHER) 12 B5 5/16’’ ARC WASHER 10 B6 5/16’’ FLAT WASHER 4 B10 Screws 2 C2 END CAP (PRE-ASSEMBLED) 2 R1 PVC COVERED CHAIN (PRE-ASSEMBLED) 4 R2A LONG EYE BOLT WITH CHAIN (PRE-ASSEMBLED) 2 R2B SHORT EYE BOLT WIT
ASSEMBLY INSTRUCTIONS Place the playground equipment on level ground and not less than 6ft (1.8m) from any structure or obstruction such as a fence, garage, house, overhanging branches, laundry line, or electrical wires. Do not install the playground equipment over concrete, asphalt, packed earth, or any other hard surface; a fall onto a hard surface can result in serious injury or death to the equipment user. Adequate overhead clearance is essential.
REFERENCE FOR LOCATION OF INSTALLATION A1 A2 A3 A5 A3 A4 A4 A5 A4 A4 STEP 1 – Assemble the top bar frame of swing set B3 A1 B4 A2 B5 B2 12
STEP 2 – Assemble the support legs of swing set A1 B2 B5 B5 B2 A3 A3 B3 B4 A4 A4 13
STEP 3 – Attach the crossbar to the support legs A1 A3 A3 B3 B6 B4 B1 B4 A5 B3 A4 B1 B6 A4 14
R5 STEP 4 – Flying Saucer Assembly R6 R5 R4 R6 R3 R3 15
STEP 5 – Attach Flying Saucer to the Swing Set Frame B3 B4 A1 A2 R1 R1 R1 B5 B3 16
Congratulations! You have now completed the swing set assembly. Please make sure to thoroughly check all parts and hardware to make sure all bolts and nuts are well secured before using the playground equipment. WARNING: Do not let children use the playground equipment until it is properly assembled and anchored.