Owner`s manual

29843-5-1012 Page 47
CAUTION: ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE WITH ALL LOCAL,
CITY AND STATE BUILDING CODES. BEFORE MAKING THE ELECTRICAL CONNECTION, MAKE SURE THAT MAIN POWER SUP-
PLY IS DISCONNECTED. THE APPLIANCE, WHEN INSTALLED, MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE WITH
LOCAL CODES OR, IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL ELECTRICAL CODE ANSI/NFPA 70 (LATEST
EDITION).
Afactoryinstalledjunctionboxislocatedonthelowerrightsideof
thereplace.Wiringmustbefedtothejunctionboxandattached
tothereceptaclethatisprovided.Leaveapproximately6"ofwire
inthejunctionboxforconnection.
Attachblackwiretoonesideofthereceptacleandwhitewireto
oppositesideofreceptacle.Thegroundwireshouldbeattached
tothegreen(ground)screw.
Installthereceptacleintothejunctionbox.Attachcoverplate.
▲
►
▼
◄
◄
JUNCTION BOX CONNECTIONS
JUNCTION BOX
BLACK
GROUNDWHITE
110 VOLT
POWER SUPPLY
JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS
Figure 62
ACCENT LAMP LIGHT REPLACEMENT - DVLL
Ifintheevent thelamporlensneeds tobereplaced,followthe
instructionsbelow:
1. Unplug the remote from the junction box or disconnect all
powertothereplace.
2. Removethedecorativefrontaccesspanel.
3. Removethe valvecovertoaccesstheareaunderneaththe
rebox.
4. Removethewingnutsoneachsideofthelightsocket.Lower
thesocketstraightdown.
5. Wearing gloves, pull the light bulb out of the socket.
Replace the light bulb with a new one of the exact type,
making sure the white gasket is in place around the bulb.
IMPORTANT: Do not handle the lamp (bulb) with bare
ngers, protect with clean dry cloth.
6. Raisethesocketandbulbstraightupontotheboltsandtighten
thewingnuts.DONOTOVER-TIGHTEN.
Your Luxury Direct Vent Gas Fireplace (DVLL ONLY) comes equipped with our
"Accent Lamp." The light has been pre-wired and is controlled from the remote.
Figure 63
NOTE:Thelampwillpullstraightoutofthesocket.
Replacewith35Watt/120VoltHalogenbulb.
Whenre-installing,ensureintegrityofgasketseal.
Lightbulbspecsifpurchasedatahardwarestore:
·120V,35W
·Halogen,GY6.35
·Base,T3Shape
ReplacementPartsNumber:
·BulbR10928
·RedcoloredlightlterR10924
▼
◄
◄
▼
WING NUTS
UNIT SHOWN FROM THE BOTTOM WITH THE BASE REMOVED FOR CLARITY.