Owner`s manual

29843-5-1012 Page 41
OPTIONAL DECORATIVE GLASS PANELS (DVLL ONLY)
NOTE: THIS NEEDS TO BE DONE BEFORE INSTALLING THE
GLASS MEDIA BEADS.
PLACING THE OPTIONAL DECORATIVE GLASS PANELS
INTO THE DVLL FIREPLACE:
Use the Glass Identication Chart as a dimensions guide for
the glass glass panel parts.
1. Removefrontglassandfrontdoorassembly.Besurethere
arenoglassmediabeadsonthemediatray.
2. Carefullyunpacktheglasspanels.Wearglovestoprevent
anyaccidentalcutsandtopreventngerprintsontheglass.
3. Placethetwo“A”panelsthroughthesmalltabsandintothe
centerrearslotsinthemediatraybase.
4. Placethetwo“B”panelsthroughthesmalltabsandintothe
outerrearslotsinthemediatraybase.
5. Placethethree“C”frontglasspanelsthroughthesmalltabs
andintothefrontslotsinthemediatraybase.
6. Installtheglassmediabeadsaroundthemediatraytohide
thesmalltabsthatholdtheglass.Theglassedgeswillbeillu-
minatedfromthelightbelowthemediatray.SeeDVLLGlass
MedialInstallationSectioninthereplaceInstallationInstruc-
tions.
GLASS IDENTIFICATION CHART
ITEM
NUMBER
PART
NUMBER
HEIGHT WIDTH QUANTITY
SUPPLIED
A R11263 3-1/2” 9-7/8” 2
B R11383 3-1/2” 8-1/8” 2
C R11261 2-1/2” 9-7/8” 3
Figure 61