Owner`s manual
29843-5-1012Page 32
Finishing The Wall for DF412BL Decorative Front With Inside Fit
Theinsidetfrontallowsfornishingoverthefaceofthereplaceandrightuptotheremovablefront.
1. Afterinstallingthereplace,installthefrontkit.
2. Locatethesidestonestops,loosenthefourfrontscrewsafewturns-donotremovethem.
3. Slipthesidestonestopunderthefourscrewsandtighten.Repeatfortheotherside.
4. Locatethesteelhoodstonestop.Loosenthe7screwsunderthetopedgeofthereplace-donotremove.Slipthehoodstone
stopunderthe7screwsandtightenwhileholdingbacktightlytothetopfaceofthereplace.
5. Securefrontfaceofthehoodstonestoptoupperreplacefacewiththreescrews.
6. Hangthefrontonthefourrectanglecut-outsonthefaceofthereplace.
7. Finisharoundthereplace,youmustuseonlynon-combustiblematerialtocoverthesteelfaceandnon-combboardonthere-
place.Allnon-combustiblenishingmaterialsmuststopatthesideandhoodstonestops.Finishingmaterialmustnotgopastthe
stonestopsofthefrontwillnott.Stopthenishingmaterialatthebottomofthevalveopeningsothevalveandfansareclearfor
service.
FINISHING THE WALL
►
►
▼
◄
55-1/2” x 13-1/2”
(141cm x 343mm)
NON-COMBUSTIBLE BOARD
HOOD
STONE STOPS
SIDE
STONE STOPS
SIDE
STONE STOPS
NON COMBUSTIBLE
BOARD
2” x 24” (5cm x 61cm)
NON COMBUSTIBLE
BOARD
2” x 24” (5cm x 61cm)
Figure 51
◄
◄
STOP THE FINISHING
MATERIAL ON TOPOF
THE HOOD STONE STOPS
STOP THE FINISHING
MATERIAL ON TOPOF
THE SIDE STONE STOPS
STOP THE FINISHING MATERIAL FLUSH
WITH THE BOTTOM OF THE VALVE OPENING
NON COMBUSTIBLE
BOARD
NON COMBUSTIBLE
BOARD
Figure 52










