Owner`s manual

29843-5-1012 Page 27
NOTE: Terminationcapshouldpassthroughthewallrestopfrom
theexteriorofthebuilding.Adjusttheterminationcapto
itsnalexteriorpositiononthebuilding.
Warning:Terminationcapmustbepositionedsothatarrowis
pointingup.
Attach the termination cap with the four wood screws provided.
Beforeattachmentofthetermination,runabeadofsiliconesealant
ratedabove250°Fonitsoutsideedgetoo,soastomakeaseal
totheexteriorwall.
NOTE: Woodscrewscanandshouldbereplacedwithappropriate
fastenersforuseonstucco,brick,concreteorothertypes
ofsiding.
CAUTION:Ifexteriorwallsarenishedwithvinylsiding,(ormaterials
thatcouldbecomediscoloredorwarp)itisnecessarytoinstalla
vinylsidingstandoff.
Thevinylsidingstandoffwillbeinstalledbetweentheventtermination
andtheexteriorwall.See Figure 39.Thishorizontalventtermination
boltsontotheatportionofthevinylsidingstandoff,soanairspace
willexistbetweenthewallandtheterminationcap.
▲
►
►
▲
▲
CUT VINYL SIDING AWAY
TO FIT STANDOFF
NUT
(4 REQUIRED)
WOOD SCREWS (4 REQUIRED)
VENT TERMINATION
BOLT(4 REQUIRED)
Figure 39
HORIZONTAL TERMINATION