Specifications

4-2
SETTING BOULDERLINK SWITCHES
Every Boulderlink system must have one “MASTER” component,
and only one component can be set to MASTER. Usually this is the
preamplifier. Power amplifiers and other products not having a
MASTER/SLAVE switch are not eligible to be “MASTER.”
SETTING BOULDERLINK ID NUMBERS
Every component is required to have a unique Boulderlink ID
number.
Each Boulder 850 Power Amplifier has a thumbwheel switch on
the rear panel. Start by setting the first switch to 0 or 1 and then going
up from there without any duplication. Use of the lowest numbers
will speed up turn on as each amplifier is allowed about three seconds
before the next. This spreads out the power line inrush currents thus
preventing house circuit breakers from unnecessary tripping. Up to 16
power amplifiers may be connected together in one Boulderlink cable
daisy chain.
BOULDER
LINK