Specifications

SETTING BOULDERLINK SWITCHES
Every Boulderlink system must have one “MASTER” component,
and only one component can be set to MASTER. Usually this is the
preamplifier. Power amplifiers and other products not having a
MASTER/SLAVE switch are not allowed to be “MASTER.”
On the 810, the Boulderlink MASTER/SLAVE switch will normally
be set to MASTER.
SETTING BOULDERLINK ID NUMBERS
Each component is required to have a unique Boulderlink ID
number. The 810 ID is preset to 20 at the factory and/or when a master
reset sequence is executed. If multiple preamplifiers are connected
together, see pages 4-5 through 4-6 for instructions on how to change
the ID numbers of the additional units.
Each Boulder power amplifier has a thumbwheel switch on the rear
panel. Start by setting the first switch to 0 or 1 and then going up from
there without any duplication. Use of the lowest numbers will speed
up turn on as each amplifier is allowed about 3 seconds before the next.
This spreads out the power line inrush currents thus preventing house
circuit breakers from unnecessary tripping. Up to 16 power amplifiers
may be connected together in one Boulderlink cable daisy chain.
BOULDER
LINK
5-3