Specifications

CARTRIDGE SET UP
PERSONALITY CARD
Each 1008 input has two slots for personality cards, one for left,
and one for right channels. The cards serve two functions– a switch
to set the electronics for the type of cartridge used at that input, and
places to solder the custom load termination resistor and capacitor.
The 1008 is shipped with all 4 cards installed in the rear panel.
The cards are set to MC, and have a load resistor installed to set the
input impedance to 100Ω. These are the most commonly used settings
for a MC cartridge.
WARNING: Press the STANDBY pushbutton until the STANDBY
indicator is off before removing or inserting the personality card.
Failure to do so might result in very loud clicks.
To remove, pull the card firmly. To insert, push the card until it
completely seats into the connector and the face is flush to the panel.
CARTRIDGE
SET UP
2-1