Product Specs

responsibility of the module through a change in FCC ID or new application. The FCC ID of the module cannot be used

on the final product. In these circumstances, the host manufacturer will be responsible for re-evaluating the end product

(including the transmitter) and obtaining a separate FCC authorization

2.7 Antennas

Antenna Specification are as follows:

Type: PCB Antenna

Gain: 2.36 dBi

This device is intended only for host manufacturers under the following conditions: The transmitter module may not be

co-located with any other transmitter or antenna; The module shall be only used with the internal antenna(s) that has been

originally tested and certified with this module. The antenna must be either permanently attached or employ a ‘unique’

antenna coupler.

As long as the conditions above are met, further transmitter test will not be required. However, the host

manufacturer is still responsible for testing their end-product for any additional compliance requirements required with

this module installed (for example, digital device emissions, PC peripheral requirements, etc.)

2.8 Label and compliance information

Host product manufacturers need to provide a physical or e-label stating “Contains Transmitter Module

FCC ID: 2A9HW-BL602” with their finished product.

2.9 Information on test modes and additional testing requirements

BLE

Operation Frequency: 2402~2480MHz

Number of Channel: 40

Modulation: GFSK

WIFI

Operation Frequency: 2412~2462MHz

Number of Channel: 11

Modulation: DSSS, OFDM

Host manufacturer must perfom test of radiated & conducted emission and spurious emission, etc according to the actual

test modes for a stand-alone modular transmitter in a host, as well as for multiple simultaneously transmitting modules or

other transmitters in a host product. Only when all the test results of test modes comply with FCC requirements, then the

end product can be sold legally.

2.10 Additional testing, Part 15 Subpart B disclaimer

The modular transmitter is only FCC authorized for FCC Part 15 Subpart C 15.247 and that the host product manufacturer

is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of

certification. If the grantee markets their product as being Part 15 Subpart B compliant (when it also contains unintentional

radiator digital circuity), then the grantee shall provide a notice stating that the final host product still requires Part 15

Subpart B compliance testing with the modular transmitter installed.