Safety Information

Page 9 of 13
Report Ref. No.: 68.210.18.0104.01
Attachment No. 1
IEC60950-1
Clause
Requirement + Test
Result - Remark
Verdict
TÜV SÜD Certification and Testing (China) Co., Ltd. Shenzhen Branch
Test Report National and Group Differences for IEC 60950-1 2
nd
Ed.+A1+A2 Rev. 10
US United States of America
US
SPECIAL NATIONAL CONDITIONS BASED ON FEDERAL REGULATIONS

1.1.1
All equipment is to be designed to allow
installation in accordance with the National
Electrical Code (NEC), ANSI/NFPA 70, the
Canadian Electrical Code (CEC), Part I, CAN/CSA
C22.1, and when applicable, the National
Electrical Safety Code, IEEE C2. Also, unless
marked or otherwise identified, installation is
allowed per the Standard for the Protection of
Electronic Computer/Data-Processing Equipment,
ANSI/NFPA 75.
P
1.1.2
Baby monitors are required to additionally comply
with ASTM F2951, Consumer Safety Specification
for Baby Monitors.
N/A
1.4.14
For Pluggable Equipment Type A, the protection in
the installation is assumed to be 20A.
P
1.5.5
For lengths exceeding 3.05 m, external
interconnecting flexible cord and cable assemblies
are required to be a suitable cable type (e.g., DP,
CL2) specified in the NEC.
For lengths 3.05 m or less, external
interconnecting flexible cord and cable assemblies
that are not types specified in the NEC are
required to have special construction features and
identification markings.
N/A
1.7.1
Equipment for use on a.c. mains supply systems
with a neutral and more than one phase conductor
(e.g. 120/240 V, 3-wire) require a special marking
format for electrical ratings.
A voltage rating that exceeds an attachment plug
cap rating is only permitted if it does not exceed
the extreme operating conditions in Table 2 of
CAN/CSA C22.2 No. 235, and if it is part of a
range that extends into the Table 2 "Normal
Operating Conditions." Likewise, a voltage rating
shall not be lower than the specified "Normal
Operating Conditions," unless it is part of a range
that extends into the "Normal Operating
Conditions."
N/A
1.7.7
Wiring terminals intended to supply Class 2
outputs in accordance with the NEC or CEC Part
1 shall be marked with the voltage rating and
“Class 2” or equivalent. The marking shall be
located adjacent to the terminals and shall be
visible during wiring.
N/A
2.5
Where a fuse is used to provide Class 2, Limited
Power Source, or TNV current limiting, it shall not
be operator-accessible unless it is not
interchangeable.
N/A