User manual

6 Operating
On delivery, the DMX start address, i.e. the DMX channel controlled by channel fader [1], is set
to 1. Proceed as follows to change the DMX start address:
1. Press [UP] or [DOWN] once to increase or decrease the DMX start address by one. The
value has to be within a range of 1 to 512.
2. If you press and hold [UP] or [DOWN], the set value changes more quickly.
ð
The new DMX start address is shown in the display.
1. Move the channel faders to the desired value. The corresponding DMX value in the
range 0 to 255 appears in the display for approximately 10 seconds.
2. To switch the display to percentage (0 to 100), press [MODE].
ð
The LED [%] lights.
3. To switch the display to DMX values (0 to 255), press again [MODE].
ð
The [0-255] LED lights.
Setting the DMX start address
Using channel faders
Operating
DMX Controller SDC-16
21
DMX controller