Manual Firmware V1.3.6

4. In the third line: Keylock and software version
The network device has a unique MAC address (48 bits, 6 bytes), with the front 24 bits being
the registered manufacturer identier and the back 24 bits being a proprietary assignment by
the manufacturer. The rst two bytes of the MAC address are factory set to 0xE0FE and the last
four bytes are calculated by the MCU's UID to prevent duplication. Do not change the MAC
address without absolute necessity!
If you need to resolve a MAC conict by changing the MAC address, follow these steps:
1. In the ‘Info’ menu, call up the submenu ‘Version’ , press [Down] twice and then [Setup] to
open the password menu.
2. Change the password with [Up] | [Down] to ‘254’ uand press [Setup] to open the menu
for changing the MAC address.
3. Change 6 consecutive bytes, press [Setup] to change the next one, save all changes and
go with [Back] back to the main menu.
The device can also be controled using ArtCommands. For the possible commands and their
functions refer to the following table.
Changing the MAC address
ArtCommands
Operating
NETcon 8-3 / 8-5
27
ArtNet DMX converter