Manual Firmware V1.3.6

1. Select ‘sACN-Cong’ to set the domain area for the sACN protocol.
2. In ‘Universe’ , choose a value between ‘00001’ … ‘63999’ .
1. Select ‘Settings’ to make general settings.
2. In ‘Sub-Mask ’ , select one of the three address ranges.
3. In ‘Local IP’ , enter the desired local IP address of the device.
4. In ‘Broadcast’ , in Input mode, select the option ‘Broadcast’ or ‘Unicast’ .
5. In ‘Target IP’ under ‘All’ , enter an IP destination address uniformly for all 8 interfaces, or
under ‘IP1’ … ‘IP8’ , enter a separate IP destination address for each interface. The rst
byte of the IP address is not displayed. The ‘Target IP’ is relevant when the device should
receive DMX signals and transform them into ArtNet or sACN signals and output them.
6. In ‘Input-Switch’ , you can select the protocol with which you want to receive the data at
the serial interface ( ‘ArtNet’ or ‘sACN’ ).
7. To set the backlight in ‘Backlight’ , select the value ‘Disable’ (no backlight) or a value of
‘1 Min’ … ‘60 Min’ (duration of illumination). If no action is taken on the device within
the set time, the backlight turns o.
Conguring sACN
Settings
Operating
NETcon 8-3 / 8-5
25
ArtNet DMX converter