Manual Firmware V1.3.3

1. Select ‘sACN-Cong’ to set the domain area for the sACN protocol.
2. In ‘Universe’ , choose a value between ‘00001’ … ‘63999’ .
1. Select ‘Settings’ to make general settings.
2. To set the backlight in ‘Backlight’ , select the value ‘Disable’ (no backlight) or a value of
‘1 Min’ … ‘60 Min’ (duration of illumination). If no action is taken on the device within
the set time, the backlight turns o.
3. Turn keylock on and o in ‘KeyLock’ .
Press for 3 seconds if you want to activate the display while the keylock is activated.
4. For the DMX intervals in output mode, select a value of ‘25’ … ‘100’ (unit ms) in ‘DMX-
Interval’ .
5. In ‘Factory’ , you can reset the device to factory default settings.
6. In ‘Input-Switch’ , you can select the protocol with which you want to receive the data at
the serial interface ( ‘ArtNet’ or ‘sACN’ ).
Conguring sACN
Settings
Operating
NETcon 8-3 / 8-5
25
ArtNet DMX converter