Manual Firmware V1.3.3

1. Select ‘ArtNet-Cong’ to set up the network connections.
2. In ‘Sub-Mask ’ , select one of the three addresses.
3. In ‘Local IP’ , enter the local IP address ‘192.168.1.10’ .
4. In ‘Net Switch’ , enter a value between ‘0’ and ‘127’ for the upper 7 bits of the 15-bit
address in the ArtDMX.
5. In ‘Sub Switch’ , enter a value between ‘0’ and ‘15’ for the middle 4 bits of the 15-bit
address in the ArtDMX.
6. In ‘SwOut’ , enter a value between ‘0’ and ‘15’ for the lower 4 bits of the 15-bit address
of the output in the ArtDMX.
7. In ‘SwIn’ , enter a value between ‘0’ and ‘15’ for the lower 4 bits of the 15-bit address of
the input in the ArtDMX.
8. In ‘Broadcast’ , in Input mode, select the option ‘Broadcast’ or ‘Unicast’ .
9. In ‘Target IP’ under ‘All’ , enter an IP destination address uniformly for all 8 interfaces, or
under ‘IP1’ … ‘IP8’ , enter a separate IP destination address for each interface. The rst
byte of the IP address is not displayed.
Conguring ArtNet
Operating
24
NETcon 8-3 / 8-5
ArtNet DMX converter