User manual

n one block per phase
n one block to one phase, two blocks to a second phases
n all blocks to one phase
Regardless of the actual use, all three blocks should always be connected.
Connect the DMX input of the device to the DMX output of a DMX controller or another DMX
device. Connect the output of the rst DMX device to the input of the second one and so on,
to form a series connection. Make sure that the output of the last DMX device in the chain is
terminated by a resistor (110 Ω, ¼ W).
Connections in ‘DMX’ mode
Installation and starting up
18
DPX-1210T NET
dimmer pack