User manual

Table Of Contents

Connect the output of the rst DMX device to the input of the second one and so on, to form a

series connection. Connect the output of this DMX chain to input A on the front or back of the

DMX Manager. Connect the output of a second DMX chain to input B on the front or back of

the DMX Manager. Connect the output on the front or rear of the DMX Manager to the DMX

input of a DMX controller or other DMX device. Make sure that the output of the last DMX

device in the chain is terminated by a resistor (110 Ω, ¼ W). Note that the ports on the front

and back can not be used in parallel.

Connections in ‘DMX’ mode

Installation and starting up

DM-2512

DMX manager