User manual

6. Re-enter the new Record code.
ð
All Channel and Scene LEDs ash three times.
The RECORD code is now changed.
If you re-enter something other than the rst time, the LEDs will
not light up. This means that changing the Record code has
failed.
WARNING!
Always remember to exit the Record mode if you do not want to con‐
tinue programming. If you forget this, you lose control of the device.
7. To quit the Record mode, press [REC EXIT] while keeping [RECORD] pressed.
8. Release both buttons.
ð
The LED of the [RECORD] turns o. You have left the Record mode.
Press [RECORD] and [EXIT] simultaneously.
ð
The change process is cancelled.
7.1.3 Programming a scene
1.
Activate the programming (
Ä Chapter 7.1.1 ‘Enabling programming’
on page 17).
Make sure the faders [Master A&B] are both set to their maximum.
([MASTER A] is set to maximum when it is at the top. [MASTER B] is set to
maximum when it is at the bottom).
2. To select the mode ‘1-48 Single’ , press [MODE SELECT]. This gives you control
over all 48 channels.
3. Create the desired scene using the channel faders 1-48. At 0 % or DMX 0, the
faders should be in position 0, at 100 % or DMX 255, the faders should be in
position 10.
4. To save the desired scene as a step, press [RECORD].
5. Repeat steps 3 and 4 until all desired steps have been stored.
You can store up to 1000 steps in memory.
6. Press [PAGE] to select a page (1-4) where you save your scenes.
To cancel the process of changing the
record code:
Operating
18
DMX DC-2448
DMX controller