User manual
Table Of Contents
- Table of contents
- 1 General notes
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 MIDI and DMX channel settings
- 9 Quick Start Guide for the main functions
- 10 Technical specifications
- 11 Plug and connection assignments
- 12 Protecting the environment
7 Operating
7.1 Starting programming
7.1.1 Enabling programming
1. Keep [RECORD] pressed.
2. While keeping [RECORD] pressed, press the Flash buttons 1, 6, 6 and 8 in
sequence.
When you turn on the unit for the rst time, the record code is 1, 6, 6
and 8. You can change the code to protect your programmes.
3. Release [RECORD] .
ð
The RECORD LED lights up.
Now you can start programming.
7.1.2 Protecting programmes
To protect your programmes, you can change the Record code. To change the
Record code, proceed as follows:
1.
Activate the programming (
Ä
Chapter 7.1.1 ‘Enabling programming’
on page 17).
2. Keep [RECORD] and [EDIT] pressed simultaneously.
3.
The record code consists of a combination of four Flash buttons, this
number may not be exceeded or fallen below.
While keeping [RECORD] and [EDIT] pressed, enter the new code using the ash
buttons.
4. Release [RECORD] and [EDIT] .
ð
The display shows ‘Cod’
5. Keep [RECORD] and [EDIT] pressed simultaneously.
Operating
DMX DC-2448
17
DMX controller