User manual

7.6 Calling chases
1. When you connect the device to the power supply, it is automatically in manual mode.
2. Press one of the six [CHASE] buttons to select the desired chase. If you press the button
again, you disable this function.
3. With [BANK UP/DOWN] you can call the steps of the chase one by one.
1. Press [Auto/Del] to enable the Auto mode. The LED [Auto trigger] in the display indicates
that the mode is activated.
2. Press one of the six [CHASE] buttons to select the desired chase. If you press the button
again, you disable this function.
3. Use [Tapsync/Display] or the [SPEED] fader to adjust the chase as desired.
You can select several chases at a time. The chases run in the sequence in which you
select them.
Manual mode
Auto mode
Operating
38
DC-1216
DMX controller