User manual

7.3 Programming scenes

1. Enabling programming mode.

2. Press one of the [SCANNERS] buttons to turn on the Fader control for the corresponding

scanner. The LED next to the selected [SCANNERS] button lights up. You can select sev‐

eral scanners at a time.

3. Use the faders to set the desired DMX values.

4. With [Page Select] you can switch from the rst level [PAGE A] to the second level

[PAGE B] to programme channels 9 – 16.

5. Press [Midi/Rec] to save the programmed scene.

6. Use [BANK UP/DOWN] to select the bank in which you want to save the scene. 30 banks

with each eight memory locations are available.

7. To save the scene to the desired location, press the corresponding [SCENES] button (1 –

8). All LEDs and the display will briey ash, indicating that the scene has been saved.

Then the display shows Bank and Scene.

8. Repeat steps 3 – 7 until all desired scenes have been saved. Finally, press the [SCANNERS]

button to turn o fader control.

Operating

DC-1216

DMX controller