User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
9. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2. To select a chase press the corresponding [CHASE] button (1 to 12). The corresponding
LED lights up.
3. Press [Tap/Disp], step indicator lights up on the display.
4.
Press [Bank] / [Bank] to manually go through each chase step. Locate the chase step
you want to delete.
5. Press [Auto/Del] to delete the chase step. When the step is deleted, all LEDs ash three
times.
6. Repeat steps 4 and 5 to delete further chase steps.
7. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
Deleting chase steps
Operating
42
DMX DC-192
DMX controller