User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
8.4.3 Editing chases
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2. To select a chase press the corresponding [CHASE] button (1 to 12). The corresponding
LED lights up.
3. Press [Tap/Disp], step indicator lights up on the display.
4.
Press [Bank] / [Bank] to manually go through each section of the chase step. Locate
the chase step to which you want to add another step.
5. Press [Tap/Disp] to exit the step mode. The step display in the display should then be o.
6.
Use [Bank] / [Bank] to select the scene bank containing the scene you want to add.
You can see the scene bank in the display by looking at the digits on the right outer side.
7. Press [Midi/Rec] to copy the step into your chase. When the step is added, all LEDs ash
three times.
8. Repeat steps 3 to 7 to add further chase steps.
Adding a chase step
Operating
DMX DC-192
41
DMX controller