User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
8.4 Chases
8.4.1 Recording chases
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2. To select a chase press the corresponding [CHASE] button (1 to 12). The corresponding
LED lights up.
3.
Use [Bank] / [Bank] to rstly select the desired scene bank and then the scene to be
recorded. You can see the scene bank in the display by looking at the digits on the right
outer side. You can also adjust the scene using the eight channel faders, the joystick or
[PAGE SELECT] . Use [PAGE SELECT] to switch among channels 1 to 8 and 9 to 16.
4. Press [Midi/Rec] to record the chase step. When the chase step is recorded, all LEDs ash
three times.
5. Repeat steps 3 and 4 to record further steps.
6. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
Operating
DMX DC-192
39
DMX controller