User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
8.3.5 Deleting all scenes
1. Turn o the controller using the mains switch.
2.
Simultaneously hold down [Program] and [Bank] and switch the controller back on
again. All LEDs ash three times when all scenes have been deleted.
8.3.6 Scene playback
1. When you turn on the controller, it starts by default in Manual / Blackout mode. All
output values are blanked out. To show the values, press [Blackout]. To determine the
respective blackout status, there is an indicator in the display that ashes when acti‐
vated and shows ‘OFF’ when deactivated. Press [Blackout] to stop the display from
ashing.
2.
Use [Bank] / [Bank] to select the scene bank that contains the scene you want to
play.
3. Use the [SCENE] buttons (1 to 8) to select the scene you want to play. The selected scene
is started. Press the same button again to end the scene, or [Blackout] to stop any
output.
Manual playback
Operating
DMX DC-192
37
DMX controller