User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
7. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
8.3.3 Copying a scene
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2.
Use [Bank] / [Bank] to select the scene bank that contains the scene you want to
copy.
3. Use the [SCENE] buttons (1 to 8) to select the scene you want to copy.
4.
Use [Bank] / [Bank] to change the scene bank.
5. Press the [Midi/Rec] and then the [SCENE] button (1 to 8) where you want to copy the
scene to. All LEDs ash three times when the scene has been copied.
6. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
Operating
DMX DC-192
35
DMX controller