User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
8. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
8.3.2 Editing scenes
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2.
Use [Bank] / [Bank] to select the scene bank that contains the scene you want to
edit. You can see the active scene bank in the display.
3. Press the [SCENE] button (1 to 8) of the scene you want to edit.
4. Select the device or devices where you want to change the settings for each scene. To
do so, press the corresponding [FIXTURE] buttons (1 to 12). The LEDs of the selected
devices light up.
5. Use the faders or the joystick to adjust the settings.
6. Press the [Midi/Rec] and then the [SCENE] button of the scene you want to edit. All LEDs
ash three times when the new settings are saved.
Operating
34
DMX DC-192
DMX controller