User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
8.3 Scenes
8.3.1 Recording scenes
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2. Select the devices you want to incorporate into your scene. To do so, press the corre‐
sponding [FIXTURE] buttons (1 to 12). The LEDs of the selected devices light up.
3. Design your scene using the eight channel faders, the joystick and [PAGE SELECT]. This
should be used to switch between channels 1 to 8 and 9 to 16.
4. When you are satised with your scene, press [Midi/Rec] to record.
5.
Use [Bank] / [Bank] , choose a scene bank for the backup. A total of 30 scene banks
are available. These can be seen in the display by looking at the digits on the right outer
side.
6. Press one of the [SCENE] buttons (1 to 8) to store. As soon as all the LEDs ash, the scene
is saved. Make sure you use a dierent button each time you save a scene so you do not
overwrite what you want to keep.
7. To record additional scenes, repeat steps 2 to 6.
Operating
DMX DC-192
33
DMX controller