User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2. Keep [MODE] pressed and press [FINE]. The LEDs for [ASSIGN] and [PAN] should light up
now.
3. Select the devices you want to delete pan / tilt reversal for. To do so, press the corre‐
sponding [FIXTURE] buttons (1 to 12). The assigned LEDs light up.
4. Keep [MODE] pressed and press [Auto/Del]to delete the settings of the selected devices.
All LEDs ash three times to conrm the deletion.
5. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
1. Turn o the controller using the mains switch.
2. Simultaneously press [Auto/Del] and [MODE] and switch the controller back on again. All
LEDs ash three times, the settings have been cleared.
Deletion Pan / Tilt joystick set‐
tings on selected devices
Deletion Pan / Tilt joystick set‐
tings on all devices
Operating
32
DMX DC-192
DMX controller