User manual

5. Press [Tap/Disp] to switch between ‘PL.XX’ and ‘PH.XX’ . ‘PL.XX’ stands for the low byte or
ne channel, generally listed as the Pan Fine channel. ‘PL.XX’ stands for the high byte or
rough channel, generally listed as the Pan channel. Set ‘PH.XX’ , press and hold [MODE]
and then press the [SCENE] button corresponding to the device's pan channel. For
example, if the device's pan channel is 1, you should press the [SCENE]button 1. Please
refer to the device's DMX table. If your device has a Pan-Fine channel, press
[Tap/Disp]until the display shows ‘PL.XX’ . Keep [MODE] and then press the [SCENE]
button corresponding to the device's pan ne channel. For example, if the device's pan
ne channel is 2, you should press the [SCENE] button 2.
6.
Press [Bank] / [Bank] to switch between ‘TL.XX’ and ‘TH.XX’ . ‘TL.XX’ stands for the
low byte or ne channel, generally listed as the Tilt Fine channel. ‘TH.XX’ stands for the
high byte or rough channel, generally listed as the Tilt channel. Set ‘TH.XX’ , press and
hold [MODE] and then press the [SCENE] button corresponding to the device's tilt
channel. For example, if the device's tilt channel is 3, you should press the [SCENE]
button 3. Please refer to the device's DMX table. If your device has a Tilt-Fine channel,
press [Tap/Disp] until the display shows ‘TL.XX’ . Keep [MODE] and then press the [SCENE]
button corresponding to the device's tilt ne channel. For example, if the device's tilt
channel is 4, you should press the [SCENE] button 4.
7. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
Operating
DMX DC-192
31
DMX controller