User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
6. Keep [Program] pressed for about two seconds or until the PROG indicator stops ashing
on the display. As soon as the blackout indicator ashes, the programme mode is deacti‐
vated.
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2. Keep [MODE] pressed and press [FINE]. The LEDs for [ASSIGN] and [PAN] should light up
now.
3. Press again [MODE] and press [FINE]. The LED for [REVERSE] should light up now.
4. Select the devices you want to assign pan / tilt reversal to. To do so, press the corre‐
sponding [FIXTURE] buttons (1 to 12). The LEDs of the selected devices light up. Ideally,
you should choose opposing devices for pan / tilt reverse For example, xtures 1, 3, 5, 7
etc. should be assigned normally. Fixtures 2, 4, 6 etc. should be set up in the reverse
direction, so the units will react in the opposite direction when you turn the joystick
around. The movement of opposing devices should be in opposite direction.
Assigning the reverse joystick
(pan / tilt reversal)
Operating
30
DMX DC-192
DMX controller