User manual

3. Select the devices you want to assign PAN to. To do so, press the corresponding

[FIXTURE] buttons (1 to 12). The LEDs of the selected devices light up.

4. Press [Tap/Disp] to switch between ‘PL.XX’ and ‘PH.XX’ . ‘PL.XX’ stands for the low byte or

ne channel, generally listed as the Pan Fine channel. ‘PL.XX’ stands for the high byte or

rough channel, generally listed as the Pan channel. Set ‘PH.XX’ , press and hold [MODE]

and then press the [SCENE] button corresponding to the device's pan channel. For

example, if the device's pan channel is 1, you should press the [SCENE] button 1. Please

refer to the device's DMX table. If your device has a Pan-Fine channel, press [Tap/Disp]

until the display shows ‘PL.XX’ . Keep [MODE] and then press the [SCENE] button corre‐

sponding to the device's pan ne channel. For example, if the device's pan ne channel

is 2, you should press the [SCENE] button 2.

Press [Bank] / [Bank] to switch between ‘PL.XX’ and ‘TL.XX’ . Press [Tap/Disp] to

switch between ‘TL.XX’ and ‘TH.XX’ . ‘TL.XX’ stands for the low byte or ne channel, gen‐

erally listed as the Tilt Fine channel. ‘TH.XX’ stands for the high byte or rough channel,

generally listed as the Tilt channel. Set ‘TH.XX’ , press and hold [MODE] and then press

the [SCENE] button corresponding to the device's tilt channel. For example, if the devi‐

ce's tilt channel is 3, you should press the [SCENE] button 3. Please refer to the device's

DMX table. If your device has a Tilt-Fine channel, press [Tap/Disp] until the display shows

‘TL.XX’ . Keep [MODE] and then press the [SCENE] button corresponding to the device's

tilt ne channel. For example, if the device's tilt channel is 4, you should press the

[SCENE] button 4.

Operating

DMX DC-192

DMX controller