User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Basics
- 8 Operating
- 9 Technical specifications
- 10 Plug and connection assignment
- 11 Protecting the environment
8 Operating
8.1 Manual operation
When you turn on the controller, it starts by default in Manual / Blackout mode. All output
values are blanked out. To show the values, press [Blackout]. To determine the respective
blackout status, there is an indicator in the display that ashes when activated and shows
‘OFF’ when deactivated. To enable manual operation, turn o Blackout, select the devices to
control using the corresponding [FIXTURE] buttons on the left side. Then use the eight channel
faders, the joystick and [PAGE SELECT] to manually control the devices.
8.2 Joystick settings
1. Keep [Program] pressed for about two seconds or until the PROG indicator ashes on the
display. When the indicator ashes, the recording mode is active and you can release the
button.
2. Keep [MODE] pressed and press [FINE]. The LEDs for [ASSIGN] and [PAN] should light up
now.
Assigning the joystick
Operating
28
DMX DC-192
DMX controller