User manual

NOTICE!
Damage due to pulsed operation
Repeated, momentary presses of the [RUN] button can damage the device and
the connected electric chain hoists.
Always press [RUN] for at least several seconds.
1. Make sure the following:
n Nobody stays in the work area of the electric chain hoists.
n The workspace is free of obstacles.
n You have a clear view of the entire work area and can completely monitor the move‐
ment process.
The device must not be used if not all conditions are fullled.
2. Set all rotary switches to position ‘0’ .
If the emergency stop button is pressed and locked: Make sure that the reason for
pressing the switch is no longer present and turn it clockwise to the operating position.
3. Connect the electric chain hoists to the unit, either via the CEE sockets or via the multi-
pin industrial connectors.
Starting up the device
Starting up
20
Chainhoist Controller CHC-4, CHC-8
motor controller