User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation and starting up
- 5 Connections and controls
- 6 Operating
- 7 Technical specifications
- 8 Protecting the environment
6.6 Scenes
6.6.1 Saving scenes
Four or nine scenes can be saved and rendered in this mode. Each number button corresponds
to a scene.
1. Press [P] or [S] to enter automatic mode.
ð
The LED of the [P] or [S] lights up. There is a click sound.
2. Use the touch dial to select one of the ten built-in colour programmes or the automatic
programme or set the run duration (see
Ä
Chapter 6.2 ‘Built-in colour programmes’
on page 26 or
Ä
Chapter 6.4 ‘Run duration’ on page 27).
3. Select one of the number buttons to which you want to save the scene and hold it down
for at least two seconds.
ð
The LEDs of all buttons ash briey once. The settings of the program, the duration
and the brightness are saved.
4. Repeat steps 1 through 3 to save additional scenes.
Operating
ART-4 RGBW / ART-9 RGBW
31
DMX controller