User manual

1. Press [Power/Program] to turn the device o.
2. Press and hold the button of the desired scene [SC1]…[SC6] that you want to restore.
3. Press [Power/Program] to turn the device back on.
4. Release the button of the selected scene [SC1]…[SC6].
ð
The status LEDs of the buttons [SC1]…[SC6] ash three times. The desired scene has
been restored.
6.3.6 Set the total number of controllable channels
1. Press [Power/Program] to turn the device o.
2. Set the corresponding channel faders [CH1]…[CH6] that you want to control. When
using [CH1] the total number of controllable channels is 1, when using [CH2], the total
number of controllable channels is 2, etc.. You can control a maximum of six channels.
3. Set [Master/Fade] to 600s.
4. Hold down [Power/Program] for three seconds.
ð
All status LEDs light up.
Operating
32
ART-6 Fade
DMX controller