User manual

NOTICE!
Possible damage by leaking batteries
Leaking batteries can cause permanent damage to the device.
Take batteries out of the device if it is not going to be used for a longer period.
NOTICE!
Risk of re due to incorrect polarity
Incorrectly inserted batteries may destroy the device or the batteries.
Ensure that proper polarity is observed when inserting batteries.
The DIP switches for setting the DMX start address are located inside the device. Make the
desired setting of the DIP switches before you wire the device.
Connect the loads to the connections on the rear panel of the device. Establish the DMX link to
the controller. Connect the mains connection terminals with a mains cable. Finally, connect the
power plug of the device to a 32 A CEE socket.
Connector
Installation and starting up
18
ART-6 Fade
DMX controller