Specifications

4 It will take 3-4 minutes for your computer and the MC200Air to connect. Be patient. Here's what will
happen: The
0 button f1ashes orange while the system reboots, then turn solid green. The AIR button will
fast-blink green
while the connection to your computer is established. Do not go to step 5 until the AIR
button lights solid green. This indicates your computer is ready to communicate with the MC200Air.
5 Launch a web browser such as
Internet Explorer®, Safari®, Firefox®,
etc. Enter http:/ /169.254.1.1
& Boston Network Setu
in the address bar.
6 Click on "Proflle Configuration".
7 Select the Wi-Fi network you want
to use from the Service Set ID drop
down list. Click Apply. If your network
requires a password you will need to
enter it. Enter the password carefully-
it is case sensitive.
Tip: If you want to rename the system
you may
do this flrst. Enter a new
name in the "Digital Media Player
Name" box,
then click "Apply".
8 An information box will be displayed -click OK.
9 Disconnect the Ethernet cable and power supply
from
the MC200Air. Wait several seconds, then
reconnect the power supply.
acoustics•
10 Press the 0 button. The system will restart and be ready to
go. The AIR button will fast-blink green while the MC200Air
establishes a
connection to your network. When the
connection process is complete the AIR button lights solid green.
COnnection Status:
Signal Strength:
Wireless Channel:
Firmware Date:
Firmware Version:
Product Version:
connected
not avaHabfe
not available
2012~04~ 15
3.8.139.9111
3.8.0
Host Firmware Version: 111
WPS PIN: 64428147
http:!/169.254.1.1
Warning: Incorrect parameters may cause undesired
behavioL To save the new settmgs, click Ok.
Cancel
Tip: If you decide later that you want to rename your MC200Air, repeat the above steps without selecting a
Wi-Fi network.
After set up, disconnect the Ethernet cable
between the MC200Air and your computer. Remember to turn
back on the internal Wi-Fi system of your computer (if you normally use Wi-Fi).
11