User's Manual

IPG Battery Status
Implantable Pulse Generator
90655621-03 Rev A 11 of 11
Note: If you accidentally locate the patch in the wrong place, or if the Charger Belt moves out
of alignment, the Charger will start beeping again. Use a new adhesive patch or readjust
the belt to place the Charger back into position.
5. When the Charger emits a series of double beeps, the Stimulator is fully charged. Turn off
the Charger, remove the Charger Belt or adhesive patch, and return the Charger to the
Base Station. Do not confuse the end of charge signal (a series of double beeps) with the
continuous beeps that indicate that the Charger is searching for the Stimulator.
Note: • The end of a charge signal is a distinct double beep, and the alignment indicator is a
steady continuous signal.
• The Remote Control will not be able to communicate with the IPG when charging.
Refer to “IPG Battery Life” in your Information for Prescribers manual for information on
Stimulator battery life.
IPG Battery Status
The patient Remote Control displays the Stimulator battery status when communicating with the
Stimulator. Refer to the Clinician’s Remote Control Directions for Use for additional information.
When the Remote Control indicates a low battery the Stimulator should be recharged as soon
as possible.
Failure to recharge may lead to loss of stimulation in less than 24 hours. After stimulation stops,
communication with the Stimulator will also cease. Until a suffi cient level of charge has been
attained, the Stimulator may not communicate with the Remote Control.