System Handbook

Charging the Implant

4. Locate the Charger over the implant. When aligned with the implant, the beeping will stop.

Secure the Charger over the implant either by pressing the adhesive side to the location, or by

attaching the Velcro

belt.

Note: If you accidentally locate the patch in the wrong place, or if the Charger moves out of

alignment, the Charger will start beeping again. Use a new adhesive patch or readjust the

Ve lc ro

belt to place the Charger back to position.

5. When the Charger emits a distinct double

beep, the implant is charged. Switch off the

Charger, remove the adhesive patch or

Velcro

belt, and return the Charger to the

Base Station.

Do not confuse the end of charge (a distinct

double beep) signal with the steady, contin-

uous misalignment signal.