User Manual

Guidelines for Trial-phase Implantation

Lead Placement

Note: Fluoroscopic evaluation of the lead position during this

procedure will aid the physician in achieving an optimum pain

coverage location, and is recommended.

1. Position, prep and drape the patient in the usual accepted manner.

Inject a local anesthetic at the needle insertion site.

2. Insert the needle into the epidural space with the opening facing

up using an angle of 45° or less.

Use only the insertion needle provided in the Lead Kit. Other

needles may damage the lead. The stamped number on the

needle hub corresponds to the orientation of the bevel,

which must face up. Turning the bevel ventral (down) may

result in lead damage. An angle of more than 45º increases

the risk of lead damage.

3. Remove the needle stylet and verify entry into the epidural space

using the standard technique.